Fine Tuner FT1, our general purpose fast "photo accelerant" for UV & Visible up to 410 nm SLA, DLP, LCD & Inkjet 3D printers
The use of Fine Tuner FT1 is ideal for increasing the print speed while maintain good quality prints in Ultraviolet and Visible SLA, DLP, LCD & Inkjet 3D printers.
Its use is essential in UV & Visible SLA, DLP, LCD & Inkjet 3D printers, which do not provide the option of changing neither the light power (mW/cm2) nor curing or exposure time (seconds), because speeds up the cure and fine tunes the quality of your prints.
Fine Tuner FT1 is supplied as a kit, which contains 1 dispenser (dropper) with 60 mL of FT1, 1 measuring flask to measure exactly the minimum volume of 3Dresyns needed for fine tuning (dependant on minimum required printing volumen of individual resin tanks (vats)) and 1 empty 250 mL black bottle to mix, keep and protect fine tuned 3Dresins from day light. Please do not expose 3Dresyns to direct natural or artificial room light to prevent curing.
Fine Tuner FT1 is supplied in two versions:
- a yellowing version which at high dosage will cause some yellowing to clear finishes, and a
- low yellowing version for designing water white "clear" 3Dresyns
Note:Fine Tuner FT1 is recommended for printers having UV/Visible light wavelengths up to 410 nm (150-410 nm range), including 405 nm blue LEDs, lasers and standard DLP projectors and LCDs. Our 60 mL dispenser of FT1 is normally used at small dosage and it is enough for fine tuning between 6-12 Litres of 3D resins.
We Also Recommend
Antiseptic Disinfectant Cleaner ADC1 & Purifier for disinfecting and preventing Corona virus spread
3D-ADD MGI-1, our Micro-organism Growth Inhibitor additive for mass disinfection of liquid 3D resins before printing
Fine Tuner FT2 ultra fast "photo accelerant" for UV & Visible up to 420 nm SLA DLP, LCD & Inkjet 3D printers
Fine Tuner FT3, very low yellowing, fast and low viscosity "photo accelerant" for UV & Visible up to 420 nm SLA, DLP, LCD & Inkjet 3D printers