Fine Tuner LB1 Bio, 100% Safe Biocompatible "Light Blocker" for SLA DLP & LCD 3D printers
Fine Tuning 3D resins
If you are not fully satisfied with the resolution of your prints it is necessary to fine tune our resins to your printer settings. When the print exhibits poor resolution is usually due to excessive light penetration (Z axis) and/or scattering (XY axis), causing light bleeding beyond specifications in the XY or Z axis.
It is recommended the use of Print Quality Fine Tuner LB1 Bio in small steps of e.g. 0.2-0.3 (and up to 0.4-0.5% steps when massive bleeding occurs) to reduce gradually light penetration to avoid overcure of the resin beyond specifications and obtain optimum resolution of your prints for your specific printer settings.
The use of Print Quality Fine Tuner LB1 Bio is essential for increasing the print resolution when printing clear and colored resins with SLA DLP & LCD 3D printers.
Print Quality Fine Tuner LB1 Bio is supplied as a kit, which contains 1 dispenser (dropper) with 60 mL of LB1 Bio, 1 measuring flask to measure exactly the minimum volume of 3Dresyns needed for fine tuning (dependant on minimum required printing volumen of individual resin tanks) and 1 empty 250 mL black bottle to mix, keep and protect fine tuned 3Dresyns from day light. Please do not expose 3Dresyns to direct natural or artificial room light to prevent curing.
Note: Print Quality Fine Tuner LB1 Bio is as effective as Fine Tuner LB1 and can be exchanged since both have the same performance yield as light blockers. Both are recommended for printers having UV/Visible light wavelegths up to 410 nm (350-410 nm range), including 405 nm blue LEDs, lasers and standard DLP projectors and LCDs. Fine Tuner LB1 Bio tends to crystallise naturally. A gentle warming (use microwave with extreme caution, water bath is best) and shake will redissolve the crystals. Alternatively, it can be shaken by hand at room temperature to make a homogeneous mixture which can be added directly to the resin.
We Also Recommend
3D-ADD MGI-1, our Micro-organism Growth Inhibitor additive for mass disinfection of liquid 3D resins before printing
Fine Tuner FT1, our general purpose fast "photo accelerant" for UV & Visible up to 410 nm SLA, DLP, LCD & Inkjet 3D printers
Fine Tuner FT2 ultra fast "photo accelerant" for UV & Visible up to 420 nm SLA DLP, LCD & Inkjet 3D printers
Fine Tuner FT3, very low yellowing, fast and low viscosity "photo accelerant" for UV & Visible up to 420 nm SLA, DLP, LCD & Inkjet 3D printers