Print Quality Fine Tuner FT2 Visible "accelerant" for SLA DLP & LCD 3D printers

Print Quality Fine Tuner FT2 Visible "accelerant" for SLA DLP & LCD 3D printers

  • 70.00 €

Print Quality Fine Tuner FT2 Visible is an accelerant additive recommended to fine tune the print quality and speed up the cure of our 3Dresyns in SLA DLP & LCD 3D printers having Ultraviolet or  Visible "daylight" lasers, LEDS, standard DLP projectors  or day light visible Liquid Crystal Display LCDs. Its use helps to resolve typical printing problems, which usually occur and are evidenced by poor print quality, to say:
  • print failure, poor print resolution, print breaking, print and supports under cure , separation of prints from the supports, others.

The use of Print Quality Fine Tuner FT2 Visible is ideal for increasing the print speed while maintain good quality prints in Ultraviolet and Visible SLA DLP & LCD 3D printers.

Its use is essential in UV & Visible SLA DLP & LCD 3D printers, which do not provide the option of changing neither the light power (mW/cm2) nor curing or exposure time (seconds), because speeds up the cure and fine tunes the quality of your prints.

Print Quality Fine Tuner FT2 Visible is supplied as a kit, which contains 1 dispenser (dropper) with 60 mL of FT2, 1 measuring flask to measure exactly the minimum volume of 3Dresyns needed for fine tuning (dependant on minimum required printing volumen of individual resin tanks (vats)) and 1 empty 250 mL black bottle to mix, keep and protect fine tuned 3Dresins from day light. Please do not expose 3Dresyns  to direct natural daylight or artificial room  light to prevent curing.


Note:  Print Quality Fine Tuner FT2 Visible  is recommended for printers having UV & Visible  light wavelengths up to 440 nm (250-440 nm range) , including 405 nm blue & violet LEDs, lasers and standard DLP projectors and daylight visible LCDs. Our 60 mL dispenser of FT2 is normally used at 0.1-1 % dosage and it is enough for fine tuning between 6-12 Litres of 3D resins. 

Fine Tuner FT2 Visible can become a bit too viscous at low room temperature e.g. in winter.  If this is the case, the usage of Fine Tuner FT3 Visible is recommended due to its lower viscosity and improved mixing properties at low temperature. 

Instructions about how to fine tune 3Dresyns to your printer settings. For more info click here

We Also Recommend