3Dresyn PEDOTEK1 is our electrically conductive hydrogel 3D resin based on PEDOT:PSS for 3D printing high conductivity materials for electronics e.g. antennas for IoT applications (HF, UHF), RFID and NFC tags, OLED, OPVs, flexible PCBs, flexible cables, etc...
Features of 3Dresyn PEDOTEK1:
- black colored conductive 3D resin which can be printed as supplied without the need of adding any conductive additives
- Sheet resistance <4500 Ohm/square at 300 microns thickness after water evaporation
- Conductivity: >1.1 S/m at 300 microns thickness after water evaporation
- Resistivity <0.1 Ohm.m at 300 microns thickness after water evaporation
- conductive hydrogel 3D resin containing c. 40% water
- hard and rigid, Shore Hardness D80 range
- medium high tensile strength >20 MPa after water evaporaton
- medium rigidity (Young modulus >1000 MPa) after water evaporation
- elongation <8%
- low viscosity, below 200 cps
- before or after printing water can be evaporated by heating until 40% water is evaporated
- up to 40% predictable shrinkage can occur once water is fully evaporated
- non water soluble material after 3D printed
- non biocompatible as liquid photoreactive 3D resin (H302 and H373 pictograms) before printed and cleansed but exhibits good biocompatiblity after fully cured and cleansed
- printable by most commercial and professional SLA, DLP & LCD 3D printers
- increased durability of the resin tank
- organo-tin free
- tuning of printing speed and resoluton needs to be dome with the help our our Fine Tuners
- instructions for use IFU can be requested after ordering