3Dresyn IM-F-SS Bio is our solvent soluble flexible photopolymer 3Dresin for printing solvent soluble sacrificial materials with SLA, DLP & LCD printers.
Features and benefits:
- photoreactive liquid 3D resin which dissolves in solvents, such as acetone, after printing
- soluble before and after printing in non polar solvents, specially in our biocompatible and ultra safe Solvent Solution SS1 Bio
- bio based from renewable resources: 80% bio content
- safe handling and printing
- supplied in clear and cyan, magenta, yellow, black and white colors
- ideal for both relatively thick prints and filigree ultra fine detailed printing
- typical printing speeds at different printing settings:
- exposure times <20-25 seconds for 50 microns z layers with medium power 4-8 mW/cm2 printers (monochrome LCD printers)
- exposure times <10-15 seconds for 50 microns z layers with high power >10-15 mW/cm2 printers (high power DLP printers)
- Shore hardness A90
- tensile and flexural strength <2MPa
- Young modulus <200 MPa
- elongation <50%
- postcuring is not required
- Heat Deflection Temperature HDT after curing <30ºC@0.45MPa
- no shrinkage during 3D printing (<1%)
- prints are 100% soluble in acetone
- organo-tin free
- printable with top-down and bottom-up printers
- recommended printing temperature 20-25ºC
- ultra low viscosity <10 cps at 25ºC
- level of printing difficulty: medium-high
Note: soluble materials may swell instead of dissolve in some printing settings, especially when cured at high relative power and energy dosage, such as with high power laser and DLP printers
