3D Adhesive HTA1 MF Bio, Hard & Tough Adhesive, Monomer Free Biocompatible

3D Adhesive HTA1 MF Bio, Hard & Tough Adhesive Monomer Free is a photoreactive durable adhesive designed for gluing 3D printed parts to plastics and metals.

This monomer free adhesive is supplied in clear or in several gingiva colors and provides hard and tough bonding with high impact resistance, high flexural strength and durable performance for professional workflows.

Designed for professional bonding workflows requiring durable adhesion of 3D printed parts to plastics and metals, including denture base assembly and related dental or technical bonding applications.

• Gluing 3D printed parts to plastics
• Gluing 3D printed parts to metals
• Bonding teeth to denture bases
• Durable hard and tough bonded assemblies

• Tensile strength: >50 MPa (ISO 527-1 / ISO 527-2)
• Flexural strength: >100 MPa (ISO 178)
• Young’s modulus: 2000-3000 MPa (ISO 527)
• Elongation at break: <3% (ISO 527)
• Notched Izod impact strength: 20-30 J/m (ASTM D256 / ISO 180)
• Shore hardness: D85-90 (ISO 868)

• Water sorption: ≤ 32 µg/mm3
• Water solubility: ≤ 1,6 µg/mm3
• Residual monomer: <0%
• Viscosity: <5000 mPas at 23°C ± 2°C (ISO 3219)
• Deflection temperature: 100-110ºC @0.45MPa (ISO 75)

• Ideal for gluing 3D printed parts to plastics and metals
• Photoreactive durable adhesive
• Non foldable at 1-2 mm without breaking
• Cures in seconds under sunlight or in any standard light box at high thickness from 0.1 to 1 cm
• Supplied in clear or in several gingiva colors
• Extra hard
• Rigid
• High impact and shattering resistance
• Provides excellent and durable bonding
• Hydrophobic, ultra low water sorption

• Apply several drops of 3D adhesive on the denture base
• After locating the teeth on the denture base, photo cure it in a light box for 5-10 minutes until the adhesive is fully cured and the teeth are fully bound to the denture base

• Synthetic resin source
• Monomer free
• Organo-tin free
• Fully compliant with the Quality requirements of ISO 20795-1 and ISO 10993-1

Final bonding performance, curing behavior, impact resistance, water resistance and suitability for the intended application depend on substrate type, surface preparation, adhesive thickness, curing conditions and workflow implementation, and must be validated by the user.

This material is supplied as a professional manufacturing material and is not marketed as a finished medical device. Final part performance and suitability must be validated by the user according to the intended application.

This technical datasheet should be used together with the relevant processing, calibration, safety and workflow documentation available in the 3Dresyns® Resources section.

Access the 3Dresyns® Technical Resources (IFU, calibration, CRT, post-processing and troubleshooting)