3Dresyn IJ OD C&B – Inkjet Photopolymer for Provisional Dental Laboratory Restorative Components

3Dresyn IJ OD C&B is a photopolymer formulation designed for high-performance inkjet 3D printing applications in professional dental laboratory workflows, specifically for provisional crown and bridge restorative components. The material is engineered to deliver a balance of strength, stiffness and dimensional accuracy, enabling the fabrication of functional temporary restorations with reliable performance.

This formulation provides controlled mechanical behavior, surface quality and precision, supporting the production of detailed and stable dental parts suitable for short-term intraoral use and laboratory validation workflows.

Designed for use in commercial and professional inkjet 3D printing systems within dental laboratories for manufacturing provisional crowns, bridges and restorative components.

• Provisional crowns
• Provisional bridges
• Temporary restorative dental components
• Dental validation and fit-check parts

• Tensile strength: >30 MPa (ISO 527)
• Flexural strength: >50 MPa (ISO 178)
• Young’s modulus: 1500–2500 MPa (ISO 527)
• Elongation at break: <5% (ISO 527)
• Shore hardness: D80–90 (ISO 868)

• Density: 0.90–1.20 g/cm³, depending on formulation and, where applicable, selected version (ISO 1675)
• Polymerization shrinkage: very low (ISO 17304); no measurable dimensional shrinkage after calibration under validated processing conditions
• Shrinkage: very low
• Resolution capability: very high
• Color stability: non-settling of color
• Inkjet viscosity: <20 mPas at 70°C and <15 mPas at 80°C (ISO 3219)
• Surface quality: high-definition surface finish

• Balanced strength and stiffness for provisional restorations
• High dimensional accuracy and fit
• Good surface finish for dental applications
• Stable performance for temporary intraoral use
• Very high resolution for detailed geometries

• Printing technology: inkjet 3D printing
• Compatible with most commercial and professional inkjet 3D printers
• Optimized viscosity for reliable jetting performance
• Supports stable processing and high-resolution output

• Biocompatible formulation for dental workflows
• Organo-tin free formulation

Material properties are measured under controlled laboratory conditions and may vary depending on printer model, jetting temperature, printing conditions, build geometry and post-processing workflow.

This material is supplied as a professional manufacturing material for dental workflows. It is not marketed as a finished medical device. Final part performance and suitability must be validated by the user according to the intended application and regulatory requirements.

This technical datasheet should be used together with the relevant processing, calibration, safety and workflow documentation available in the 3Dresyns® Resources section.

Access the 3Dresyns® Technical Resources (IFU, calibration, CRT, post-processing and troubleshooting)