3Dresyn CD Low-Cost Conceptual Design Prototyping Resin

3Dresyn CD is a Conceptual Design 3D printing resin developed for fast, reliable and cost-effective professional proof-of-concept and model fabrication. It is engineered to deliver good print definition and sufficient mechanical performance for early-stage validation of geometry and visual assessment.

Designed for use in vat photopolymerization systems (SLA, DLP and LCD) within professional environments for conceptual validation workflows.

• Conceptual design models and proof-of-concept parts
• Dental models for thermoforming workflows (indirect use)
• Prototyping and design validation
• General-purpose visual models

• Tensile strength: 20–30 MPa (ISO 527-1 / ISO 527-2)
• Flexural strength: 20–30 MPa (ISO 178)
• Young’s modulus: 1200–1600 MPa (ISO 527)
• Elongation at break: <5% (ISO 527)
• Shore hardness: D70 (ISO 868)

• Density: 0.90–1.20 g/cm³, depending on formulation and, where applicable, selected version (ISO 1675)
• Low viscosity (<200 mPa·s)

• Fast curing for high-throughput printing
• Moderate rigidity with minor flexibility
• Good dimensional accuracy for visual validation
• Optimized for iterative workflows

• Printing technologies: SLA, DLP and LCD
• Fast curing: <5–7 seconds per layer (50 µm)
• Printable on most commercial systems
• Increased durability of the resin tank
• Organo-tin free

Material properties are measured under controlled conditions and may vary depending on equipment and processing parameters.

This material is supplied for professional prototyping and model fabrication. It is not marketed as a medical device.

This technical datasheet should be used together with the relevant processing, calibration, safety and workflow documentation available in the 3Dresyns® Resources section.

Access the 3Dresyns® Technical Resources (IFU, calibration, CRT, post-processing and troubleshooting)