3D-ADD UVP2, black color UV protection additive

3D-ADD UVP2 is a black color UV Protection additive for protecting 3Dresyns against degradation caused by long term UV light exposure.

It protects 3D printed 3Dresyns from UVA (320 to 400 nm), UVB (280 to 320 nm) and UVC (200 to 280 nm).

Designed for use in 3Dresyns systems to protect printed materials against degradation caused by long term UV light exposure.

• Protecting 3Dresyns against degradation caused by long term UV light exposure

• Density: 0.90–1.20 g/cm³, depending on formulation and, where applicable, selected version (ISO 1675)
• Recommended dosage: between 0.4-0.8% in high power SLA laser based and DLP printers
• Recommended dosage: between 0.2-0.4% in low power SLA LCD printers to preserve printability
• Black color

• Its use can replace the need of using any of our Fine Tuners LB "resolution increasers" to avoid over decreasing printing speed

• Excessive dosage will slow down print speed
• Add it carefully in successive steps of 0.1%, keeping in mind that overdosing can slow down printing speed beyond your expectations
• Please do not expose any 3D resins to natural or room light to prevent their curing.

• Material Safety Data Sheet "MSDS" free of hazards and pictograms

Excessive dosage will slow down print speed, consequently add it carefully in successive steps of 0.1%, keeping in mind that overdosing can slow down printing speed beyond your expectations.

This material is supplied as a professional manufacturing material and is not marketed as a finished medical device. Final part performance and suitability must be validated by the user according to the intended application.

This technical datasheet should be used together with the relevant processing, calibration, safety and workflow documentation available in the 3Dresyns® Resources section.

Access the 3Dresyns® Technical Resources (IFU, calibration, CRT, post-processing and troubleshooting)