3D-POWDER SLS TPE15-150, fine & narrow particle size distribution ThermoPlastic Elastomer PEBA powder for high resolution SLS printing

3D-POWDER SLS TPE15-150 is a specifically designed fine and narrow particle size distribution thermoplastic elastomer PEBA powder for SLS printing of high accuracy and resolution TPE PEBA printed parts.

This black thermoplastic elastomer SLS powder is designed for direct SLS printing of high quality flexible and elastic parts.

Designed for selective laser sintering of flexible and elastic thermoplastic elastomer parts requiring high accuracy and high resolution.

• Direct SLS printing of high quality flexible and elastic parts
• High accuracy and high resolution SLS printed TPE PEBA parts

• Tensile strength: 40 MPa (ISO 527-2)
• Flexural strength: 45-50 MPa (ISO 178)
• Young’s modulus: 60-80 MPa (ISO 527-2)
• Flexural modulus: <300 MPa (ISO 178)
• Elongation at break: >300% (ISO 527-2)
• Izod impact strength, notched: <600 J/m (ASTM D256 & ISO 180)
• Shore hardness: D50 (ISO 868)

• Density: 1.15-1.17 g/cm³ (ISO 1183-1)
• Water absorption after 24 hours: <1% (ISO 62)
• High accuracy and resolution of final products: 50-100 microns depending on laser spot size and layer thickness

• Heat deflection temperature at 0.45 MPa: <65ºC (ISO 75)
• Vicat softening temperature: 110-115ºC (ISO 306/B50)
• Melting temperature: 145-150ºC (ISO 11357-3)
• Service temperature: from -30ºC up to +120ºC continuous / +140ºC short term

• Ideal SLS powder for direct SLS printing of high quality flexible and elastic parts
• Black thermoplastic elastomer SLS powder with very high flexibility and mechanical strength
• Printable by most plastic / polymer powder SLS printers
• Similar properties and printing settings to Poly Ether Block Amide PEBA powders
• Excellent flow and levelling

• Typical narrow particle size distribution in microns, not to be considered a specification:
• D100: 200 (100% of particles have less than 200 microns)
• D90: 150 (90% of particles have less than 150 microns)
• D50: 60 (50% of particles have less than 60 microns)
• D10: 15 (10% of particles have less than 15 microns)
• D1: 3 (1% of particles have less than 3 microns)
• Recommended plastic or polymer powder SLS printers: SLS printer compatibility
• Suitable for FORMIGA P 110 Velocis, EOS P 396, EOS P 770 and EOS P 500
• Recommended printing process: use the std printing parameters of your equivalent polymer powder and follow 3Dresyns IFU for SLS printing

• Thermoplastic elastomer PEBA powder
• Black powder

The reported properties may vary depending of part design and manufacturing practices. It is the manufacturer’s responsibility to adjust the printing parameters and validate the suitability of the printed parts for the intended use. 3Dresyns makes no guarantee of properties, expressed or implied, regarding the accuracy of these results to be obtained from the use thereof.

This material is supplied as a professional manufacturing material and is not marketed as a finished medical device. Final part performance and suitability must be validated by the user according to the intended application.

Use these related 3Dresyns pages to navigate adjacent material and process routes within the same technical workflow.

• High-Performance SLS Powders

This technical datasheet should be used together with the relevant processing, calibration, safety and workflow documentation available in the 3Dresyns® Resources section.

Access the 3Dresyns® Technical Resources (IFU, calibration, CRT, post-processing and troubleshooting)