3Dresyns - 24/7 services and fast Worldwide deliveries. Start ordering by clicking here!

Fine Tuner LB2 Bio ULWA, resolution-er for improving resolution with no fluorescence and ultra low water absorption

Regular price 130.00 €

Shipping calculated at checkout.
Fine Tuner LB2 Bio ULWA is a 100% safe biocompatible resolution-er with no fluorescence and with ultra low water absorption (ULWA: <15 µg/mm3), ideal for Microfluidic applications, and with a Material Safety Data Sheet "MSDS" free of hazards and pictograms, It is recommended to reduce Light Bleeding (LB) or undesired overcure in biomedical applications where the highest safety and biocompatibility standards are required.
Fine Tuner LB2 Bio ULWA is a clear resolution additive developed to improve XYZ resolution by reducing light penetration, scattering and overcure of prints beyond specifications and "support fusing or merging" of our resins in SLA DLP printers working with 365 and 385 nm, from 350 to 390 nm.

Fine Tuning 3D resins

If you are not fully satisfied with the resolution of your prints it is necessary to fine tune our resins to your printer settings. When the print exhibits poor resolution is usually due to excessive light penetration (Z axis) and/or scattering (XY axis), causing light bleeding beyond specifications in the XY or Z axis.

It is recommended the use of Fine Tuner LB2 Bio ULWA in steps of 0.5% steps to reduce gradually light penetration to avoid overcure of the resin beyond specifications and obtain optimum resolution of your prints for your specific printer settings.

The use of Fine Tuner LB2 Bio ULWA is essential for increasing the print resolution when printing clear and colored resins with SLA DLP 3D printers.

It is supplied as a kit, which contains the product, one graduated beaker and one empty 250 mL black bottle to measure, mix, keep and protect the 3D resins from daylight. Please do not expose any 3D resins to natural or room light to prevent their curing.

Fine Tuner LB2 Bio ULWA tends to crystallise naturally. A gentle warming (use microwave with extreme caution, water bath is best) and shake will redissolve the crystals. Alternatively, it can be shaken by hand at room temperature to make a homogeneous mixture which can be added directly to the resin. Use it in steps of 0.5% until the depth of cure at long times (eg 100 seconds) is below 2-3 times the chosen z layer for printing.

Instructions about how to fine tune 3Dresyns to your printer settings. For more info click here