Print Quality Fine Tuner FT1 "accelerant"  for SLA DLP & LCD 3D printers

Print Quality Fine Tuner FT1 "accelerant" for SLA DLP & LCD 3D printers

  • 60.00 €

Print Quality Fine Tuner FT1 is an accelerant additive recommended to fine tune the print quality and speed up the cure of our 3Dresyns in SLA DLP & LCD 3D printers having Ultraviolet or  Visible lasers or LEDS up to 410 nm or standard DLP projectors and LCDs. Its use helps to resolve typical printing problems, which usually occur and are evidenced by poor print quality, to say:
  • print failure, poor print resolution, print breaking, print and supports under cure, separation of prints from the supports, others.

The use of Print Quality Fine Tuner FT1 is ideal for increasing the print speed while maintain good quality prints in Ultraviolet and Visible SLA DLP & LCD 3D printers.

Its use is essential in UV & Visible SLA DLP & LCD 3D printers, which do not provide the option of changing neither the light power (mW/cm2) nor curing or exposure time (seconds), because speeds up the cure and fine tunes the quality of your prints.

Print Quality Fine Tuner FT1 is supplied as a kit, which contains 1 dispenser (dropper) with 60 mL of FT1, 1 measuring flask to measure exactly the minimum volume of 3Dresyns needed for fine tuning (dependant on minimum required printing volumen of individual resin tanks (vats)) and 1 empty 250 mL black bottle to mix, keep and protect fine tuned 3Dresins from day light. Please do not expose 3Dresyns  to direct natural or artificial room  light to prevent curing.


Note:  Print Quality Fine Tuner FT1  is recommended for printers having UV/Visible  light wavelengths up to 410 nm (250-410 nm range), including 405 nm blue LEDs, lasers and standard DLP projectors and LCDs. Our 60 mL dispenser of FT1 is normally used at small dosage and it is enough for fine tuning between 6-12 Litres of 3D resins. 

Instructions about how to fine tune 3Dresyns to your printer settings. For more info click here

We Also Recommend